Brembo Single Line Banjo Bolt w/ Pressure Switch/06261030

Description The Brembo Single Line Banjo Bolt w/ Pressure Switch is something you will need when you purchase a new Brembo master cylinder and would like to use your OEM/Stock brake light. This proper banjo bolt will attach your new BREMBO master cylinder to your brake lines. A banjo bolt is a perforated bolt that goes through the loop at the end of a brake line and fastens into the master cylinder. You may need to get a new banjo bolt (if your going to need your OEM Brake light to function because Brembo uses a different thread pitch and you need to get the correct number of washers to form a tight seal on the banjo bolt. These banjo bolts require 2 copper washers(sold separately). These bolts are used with most aftermarket brake line configurations(i.e.. one brake line between the master cylinder and caliper & one line between calipers). This includes the pressure switch to activate the brake light.   Single Banjo Bolt pressure switch WILL NOT work for brake lines that have a two (Double) banjo fitting attachment at banjo bolt location. Thread Pitch: M10x1.0 Designed for Brembo Master Cylinders. Universal Wire Harness Connector: Modification WILL BE required to connect to OEM wire harness. No Mating connector available from Brembo. Thread pitch: M10x1.0 (for Brembo Master Cylinders) Banjo bolt type: Single (for ONE brake line off of the master cylinder) Application: Universal (wiring modifications may be required) Crush Washers: Not included